Users-Edit Groups; Figure 42- Edit Groups Page - Network Technologies ENVIROMUX-SEMS-16 Installation And Operation Manual

NTI SERVER ENVIRONMENT MONITORING SYSTEM

Users-Edit Groups

Groups are used to create a common relationship between sensors. From the Administration->Users>Edit Groups page the
user with administrator permissions can assign names for the groups sensors belong to.
For example, suppose there are two sensors installed in Server Room #1: a Temperature Sensor and a Door Contact Sensor. The
User responsible for monitoring Server Room #1 would like to be notified when either one of the sensors is in alert status. This
can be accomplished in two ways:
1. A single group named "Server Room #1" is created. Both sensors located in Server Room #1 are assigned to this group
(from the sensor configuration page (page 27)). The User can then subscribe to the "Server Room #1" group (from the
"Groups" section of the User Profile page (page 41)), and select the method in which to be alerted (from the "Contacts"
section of the User Profile page). The User will now receive alerts from all sensors in the "Server Room #1" group.
2. Two groups are created: one named "Temperature Sensors" and one name "Contact Sensors." Each sensor is assigned
to its respective group (from the sensor configuration page (page 27)). The User can then subscribe to both groups (from
the "Groups" section of the User Profile page (page 41)) and select the method of alert contact. The User will now
receive alerts from all sensors in the "Temperature Sensors" group and the "Contact Sensors" group. However, some
sensors in these groups may not be located in Server Room # 1.

Figure 42- Edit Groups Page

42
Up to 16 groups can be assigned.