Ip Devices; Restore Settings To Defaults; Reboot; Logout And Exit - Network Technologies ENVIROMUX-SEMS-16 Installation And Operation Manual

NTI SERVER ENVIRONMENT MONITORING SYSTEM

IP Devices

To view the IP device status screen, press <7> at the Monitoring Menu. The screen shows the description, value, and status of
each device. Pressing any key will return the user to the Monitoring Menu.
IP Devices Status
DESCRIPTION VALUE STATUS
------------------------------------------------
Press any key to continue

Restore Settings to Defaults

To restore all settings in the ENVIROMUX to default settings, press <9> from the Main Menu. All user programmed settings will
be lost and restored back to factory default settings.

Reboot

To reboot the ENVIROMUX, press <A> from the Main Menu. A prompt will appear asking if you are sure you want to continue.
Press <Y>. The ENVIROMUX will reboot and the user will need to login again to restore the connection after approximately 60
seconds.

Logout and Exit

It is important that the user logout of the RS232 or Telnet menu when finished. There is no automatic logout in this program, so
unless the user logs out, anyone can use this connection as long as it is left open.
To logout and exit the ENVIROMUX, press <B> from the Main Menu. A message will immediately appear:
Connection closed...
Press <Enter> to reconnect.

Upgrade Firmware

Note: To upgrade the Firmware, a LAN connection is required, either directly using a crossover cable (specs on page
72), or through the Ethernet (page 13).
1. To upgrade the Firmware, press <C> from Main Menu (see page 53). A prompt will appear asking if you are sure you want to
continue. Press <Y>.
Note: Take note of the Firmware version currently in place (shown in Figure 57 as V1.1) for reference after this
procedure.

Figure 57- Telnet Main Menu

61