Change Password; Enable/Disable Telnet Server; Snmp Agent Configuration Submenu; Enable/Disable Snmp Agent - Network Technologies ENVIROMUX-SEMS-16 Installation And Operation Manual

NTI SERVER ENVIRONMENT MONITORING SYSTEM
To change SMTP port, press <A> from Network Configuration Menu. The old port will be displayed between parentheses and the
system will ask for a new value.
Most SMTP servers require authentication, i.e. the user connects to that server using a name and a password. To toggle between
non-authenticated and authenticated mode, press <B> (or <b>) from Network Configuration Menu.
To change the user name, press <C> (or <c>) and to change the password, press <D> (or <d>). A maximum of 63 characters
can be used for either the user name or password.

Change Password

To enter into this submenu, press <4> from Main Menu
A request to type the current password will be displayed. If a wrong password is entered, the user will be logged out from the Main
Menu.
After introducing the correct current case-sensitive password, the user will be prompted to type and retype the new password. If
they match and the length is smaller than 80 characters (alphanumeric) but larger than 5 characters, the password will be
accepted and changed to the new one, otherwise the operation should be repeated.

Enable/Disable Telnet Server

This submenu allows the operator to disable or enable the Telnet server running on the system according to his needs. Press <5>
from Main Menu. The following text will appear on the screen (example for a currently disabled telnet Server):
The Telnet Server is currently disabled
Press <Space> to enable it, other key to return
The setting will be effective after rebooting the unit...
After pressing <Space Bar> the setting will be changed and the system will show on the screen:
Telnet Server enabled!
Do you want to reboot now? (y/n)
The operator can choose to press <Y> and the system will reboot instantly or press <N> and continue to work. If <N> was
pressed, the system will keep the old status until the first re-boot.

SNMP Agent Configuration Submenu

To enter this submenu, press <6> from main Menu. The following text will be displayed:
SNMP Agent Configuration
========================

0. Enable/Disable SNMP Agent

1. Enable/Disable SNMP Traps
2. Read Only Community String
3. Read-Write Community String
0. Return to Main Menu
Hit a key from <1> to <4> to configure the SNMP system, or <0> to return.
Enable/Disable SNMP Agent
The SNMP agent is used to monitor and control sensors and settings of the system from a remote station using SNMP (v1, v2)
protocol. The SNMP agent can be disabled or enabled by the operator by pressing <1>. The system will display the current status
of the SNMP agent and will ask the operator to press <Space Bar> to toggle the status. After saving the change, the system will
ask the operator to press <Y> to reboot the system or <N> continue running. This change will become effective after the first re-
boot.
56