Table of Contents
Advertisement
ENTER/EXIT PROGRAMMING MODE
Disable Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
on page 276
Select Disable Character Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
on page 277
Select Enable Character Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
48
GRYPHON™ I GD/GBT/GM4500
for more detailed programming instructions.
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.
0x44 = Disable Character is 'D'
for more detailed programming instructions
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.
0x45 = Enable Character is 'E'
RS-232/USB-COM INTERFACES
Disable Character"
$CR2DC
CANCEL
Enable Character"
$CR2EC
CANCEL
Advertisement
Table of Contents
