Disable Character; Enable Character - Datalogic PowerScan PBT950X Product Reference Manual

Enter/Exit Programming Mode

Disable Character

Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts
with normal operation of these characters. 8-bit data is not recognized when the option
Data Bits
See page 276
Select Disable Character Setting

Enable Character

Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands con-
flicts with normal operation of these characters. 8-bit data is not recognized when the
option
See page 277
Select Enable Character Setting
36
has been set as 7 Data Bits.
for more information on setting this feature.
0x44 = Disable Character is 'D'
DEFAULT
Data Bits
has been set as 7 Data Bits.
in "References" for more information on setting this feature.
0x45 = Enable Character is 'E'
DEFAULT
PowerScan™ PD953X/PBT950X/PM950X