Micro Pdf417 Length Control; Micro Pdf417 Set Length 1 - Datalogic QuickScan QD24 Series Product Reference Manual

Enter/Exit Programming Mode

Micro PDF417 Length Control

This feature specifies either variable length decoding or fixed length decoding for this symbol-
ogy.
For variable length decoding, a minimum and maximum length may be set.
Variable Length:
For fixed length decoding, two different lengths may be set.
Fixed Length:
DEFAULT
$CMILC01(CR)
Micro PDF417 Length Control = Fixed Length

Micro PDF417 Set Length 1

Specifies one of the bar code lengths for
the minimum label length if in
Mode. Length includes the bar code's data characters only. Characters can be set from 0001 to
0366 characters (pad with zeroes) in increments of 01. Any value greater than 0366 will be
considered to be 0366.
See page 243 for detailed instructions on setting this feature.
$CMIL1
Select Micro PDF417 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
198
Micro PDF417 Length Control on page
Variable Length
0001 = Length 1 is 1 Character
DEFAULT
$CMILC00(CR)
Micro PDF417 Length Control = Variable Length
Mode, or the first fixed length if in Fixed Length
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
Appendix D, Keypad
characters in
your desired character(s). End by scanning the ENTER/
EXIT bar code again.
~
QuickScan™ I QD24XX/QBT24XX/QM24XX
198. Length 1 is
representing
CANCEL