Removing Punch Waste - Canon imageRunner 6020 Reference Manual Reference Manual

7

Removing Punch Waste

When the punch waste tray becomes full, a screen similar to the one shown below
appears on the touch panel display. Follow the procedure described below to
remove the punch waste.
7
IMPORTANT
When the punch waste tray is full, you cannot make copies or prints using the Hole
Punch mode.
NOTE
This procedure is only required when the Puncher Unit-B1 is attached to the machine.
7-40 Finisher-F1/Saddle Finisher-F2/Puncher Unit-B1
Continue to follow the instructions on the touch panel display.
NOTE
The screen indicating how to remove the paper jam will remain displayed until the
paper jam has been cleared. (See "Screen Shown When There Is a Paper Jam," on
p. 6-2.)