List Of Error Codes Without Messages - Canon imageRunner 6020 Reference Manual Reference Manual

There are too many sub-directories.
Cause : You have exceeded the number of characters you can enter.
Remedy : You cannot specify the path. Specify a shorter path.
No response.
Cause : An unspecified error occurred.
Remedy : Contact your system manager.

List of Error Codes without Messages

If the job or operation does not complete correctly, check the End Code, and
perform the necessary operations according to the End Code displayed. You can
check the End Code in the Details screen under Log in the System Monitor screen.
(See "Checking Job Details," on p. 2-8.)
If a Send job or Receive job does not end normally, the error code is printed in the
Results column on the Activity Report and Send Result Report. (See "Specifying
Report Settings," on p. 3-68.)
Take the necessary procedures depending on the error code.
NOTE
If a send job is canceled, <STOP> appears in the Results column.
#022
Cause : Forwarding cannot be performed because the contents of the Group Address
specified as forwarding destinations have been deleted or are only User
Inboxes.
Transmission cannot be performed because, when you send documents to
destinations registered in an Address Book, the destinations are deleted from
the Address Book while awaiting transmission.
Remedy : Set the forwarding destinations/addresses in the Address Book correctly.
#037
Cause : You could not receive documents because there was no memory available.
Remedy : Erase error documents or unwanted documents in order to make memory
available. (See Chapter 4, "Using/Arranging Documents Stored in an Inbox," in
the Mail Box Guide.)
List of Error Messages
6
6-37