Staple Mode - Canon imageRunner 6020 Reference Manual Reference Manual

s Staple Mode
This function automatically collates print sets into page order, staples the sets, and
outputs them.
CAUTION
Do not put your hand in the tray's stapling area when the machine is equipped
with the Finisher. This may result in injury.
IMPORTANT
•
You cannot set the Staple mode when printing on transparencies, tracing paper, and
labels.
•
You cannot corner staple STMTR-size paper.
•
You cannot double staple LGL, LTRR, or STMTR-size paper.
NOTE
•
If the number of sheets to staple in one set exceeds 30 (for 11" x 17", LGL, and LTRR
size) or 50 (for LTR size), stapling can not be performed. Only Collating is performed.
•
If the machine stops while stapling, and a message <Load staples> appears, this means
that almost all of the staples have been used, and the staple case must be replaced. In
this case, replace the staple case. (See "Replacing the Staple Cartridge in the Stapler
Unit," on p. 7-18.)
•
Copies are stapled in the following places.
When an original is placed on the platen glass:
7
7-12 Finisher-F1/Saddle Finisher-F2/Puncher Unit-B1
Corner Staple Area
Upper Left
V
C B A
Upper Right
Lower Right
Lower Left
Upper Left
C B A
Upper Right
Lower Right
Lower Left
Double Staple Area
V
C B A
V
C B A
Left Side
Right Side
Left Side
Right Side