Performing A Testprint - Intermec PF8d User Manual

Performing a Testprint

PF8d and PF8t Desktop Printer User's Guide
4 Insert the round connector on the power cord into the power
receptacle in the back of the printer.
5 Insert the power cord plug into an AC socket.
6 Turn the printer on.
7 The status LED will change from red to green indicating that the
power is turned on.
Use the following procedure to perform a testprint.
1 Load media in the printer. For help, see the next section,
Media.
2 Press and hold the Feed button while turning the printer on. The
status LED blinks green for 2 seconds, blinks red for 2 seconds,
and then blinks green again.
3 If using continuous stock or gap media, release the Feed button
when the LED is blinking green.
If using black marked media, release the Feed button when the
LED is blinking red.
4 The printer automatically adjusts the label gap sensor and media
feed according to the characteristics of the media. The printer may
feed three to four labels before the adjustment is completed. If you
are using self-strip media, remove the labels as they are fed out.
After a short delay, a test label will print and the printer will enter
Dump mode. See the
Printer Programmer's Reference Manual
information about Dump mode.
5 Press the Feed button once to return to normal operation, or press
and hold the Feed button for at least 3 seconds after the test label
prints to reset the printer to the default settings. The status LED
turns red to indicate that the printer was reset to the default
settings and then turns green.
Refer to the ESim for the PC4, PF8, PD41, and PD42 Printer
Programmer's Reference Manual
of the test label.
Chapter 1 — Using the PF8 Printers
ESim for the PC4, PF8, PD41, and PD42
for an illustration and explanation
Loading
for additional
31