Clear Vertical Tabs In Channel; Select Vertical Tab Channel; Using Character Sets And User-Defined Functions - Intermec 6822P User Manual

Chapter 4 — Control Code Definitions

Using Character Sets and User-Defined Functions

60
c is the channel number (range: 0-7), n1 is the first tab (range of values
for tab stops: 1-255), n2 is the second tab (all tabs must be in ascending
order), ... are subsequent tabs (maximum number of tabs is 16), nk is the
last tab to set (any value less than the previous tab value acts as a
terminating character), and NUL is the terminating character.

Clear Vertical Tabs in Channel

Clears all vertical tab stops in the specified channel. This is a variant
behavior of the Set Vertical Tabs in Channel function, where the NUL
acts as an early terminating character, since this function normally clears
the existing tabs before setting any new tabs.
Format
Decimal
27 98 c 0

Select Vertical Tab Channel

Selects a specified vertical tab channel. It sets up the current tabs from
that channel. Once this function is performed, all subsequent Perform
Vertical Tab commands use the tab stops from the list retrieved from the
specified channel. At power on, the printer uses the tabs stored in
channel 0.
Format
Decimal
27 47 c
c is the channel number (range: 0-7).
You can install different character sets on the printer. In some cases more
than one character set may be present at one time, depending on the
amount of available font memory. The 6820 reserves 438 K of memory
for installing fonts in flash memory. You can install fonts using NPCP or
the Printer Configuration Utility.
Hex
1B 62 c 00
Hex
1B 2F c
6820 Series 80-Column Printer User's Manual
ASCII
ESC "b" c NUL
ASCII
ESC "/" c