Prepare The Fireplace; Stand-Off Assembly & Installation - kozy heat DASSEL DSL-36 Installation And Operation Manual

STAND-OFF ASSEMBLY & INSTALLATION
IMPORTANT: THE TOP STAND-OFF BRACKETS MUST BE
FORMED AND ATTACHED PRIOR TO POSITIONING THE
FIREPLACE INTO FRAMED OPENING.
The top stand-off brackets and stand-off heat shield are attached to the fireplace top in a flat state for shipping.
1. Remove and save the (4) screws securing stand-off heat shield and stand-off brackets.
2. Form each stand-off bracket as shown.
3. Re-attach stand-off brackets to fireplace using screws previously removed along with (4) screws provided in fireplace
components packet.
4. Form stand-off heat shield and attach to stand-off brackets with (2)screws provided in the fireplace components packet.
(Flange on stand-off heat shield faces „up‟ and to the back of fireplace).
STAND-OFF BRACKETS
AS SHIPPED
ATTACH BOTH STAND-OFF BRACKETS BY
ALIGNING WITH HOLES IN FIREPLACE TOP.
SECURE WITH (4) SCREWS AS SHOWN.
WARNING:
NON-COMBUSTIBLE ZONE:
STAND-OFFS PROVIDE THE 10" (254 mm)
MINIMUM CLEARANCE TO HEADER. USE
ONLY NON-COMBUSTIBLE MATERIAL IN
THIS AREA FOR THE ENTIRE WIDTH OF
FIREPLACE. DO NOT USE WOOD,
SHEETROCK ETC. IN THIS ZONE.
NOTE: OTHER CLEARANCES MUST BE
MAINTAINED. REFER TO PAGE 15 FOR
MORE INFORMATION.

PREPARE THE FIREPLACE

REMOVE SCREWS SECURING
EACH STAND-OFF BRACKET
STAND-OFF BRACKETS
INSTALLED
FORM STAND-OFF BY BENDING
AT PERFORATIONS AS SHOWN
CAUTION: NEVER PERMANENTLY REMOVE
THESE ASSEMBLIES FROM THE FIREPLACE -
THEY MUST BE SECURED IN PLACE
REGARDLESS OF FINISH MATERIAL USED.
PAGE 10
CAUTION:
STAND-OFF
BRACKETS ARE NOT
LOAD BEARING.
FORMED STAND-OFF
ATTACH STAND-OFF HEAT SHIELD BY
ALIGNING WITH HOLES IN STAND-OFF
BRACKETS. SECURE WITH (4) SCREWS
AS SHOWN.