Prepare The Fireplace; Nailing Flange Assembly And Installation; Glass Frame Assembly Removal; Glass Frame Assembly Installation - kozy heat Windim-WDM 56101 Installation And Operation Manual

NAILING FLANGE ASSEMBLY & INSTALLATION
1. Remove (4) nailing flanges from fireplace sides.
2. With the 1/4" (6 mm) stand-offs on nailing flanges facing away from fireplace, align nailing flange with holes on outside corners of
fireplace. Secure with screws (provided in components packet) through slots in nailing flanges.
3. Bend perforation on nailing flange until parallel with fireplace face. Do not bend toward fireplace face.
4. Position framing stud against 1/4" (6 mm) stand-off (located on backside of nailing flange). Secure with nails or screws.
NOTE: Depending on facing material, tabs can be adjusted forward or back up to 1/2" (13 mm).
CAUTION: NEVER PERMANENTLY REMOVE THESE ASSEMBLIES FROM FIREPLACE - THEY MUST BE SECURED IN PLACE REGARDLESS OF
FINISH MATERIAL USED.
Figure 12a
WARNING: DO NOT OPERATE THIS FIREPLACE WITH GLASS REMOVED, CRACKED OR BROKEN. REPLACEMENT OF GLASS ASSEMBLY,
#700-07T SHOULD BE DONE BY A LICENSED OR QUALIFIED SERVICE PERSON.
WARNING: DO NOT REMOVE GLASS ASSEMBLY WHEN HOT!
REMOVE GLASS FRAME ASSEMBLY
Upper grill must be removed and lower grill opened prior to removing glass frame assembly.
A. Locate spring-loaded handles securing glass frame assembly at bottom of firebox.
B. Pull bottom handles out and „down‟ to release glass frame assembly bottom.
C. Pull bottom of glass frame assembly out and lift up off tabs at top of firebox.
Figure 12b
INSTALL GLASS FRAME ASSEMBLY
A. Place glass frame assembly top over tabs at top of firebox.
B. Pull bottom handles out and „up‟ to secure glass frame assembly bottom.

PREPARE THE FIREPLACE

1/4" (6mm) CLEARANCE
FRONT VIEW
NAILING FLANGE
FRAMING STUD
GLASS FRAME ASSEMBLY
TOP VIEW
STAND-OFF
1/4" (6mm)
FRAMING STUD
CLEARANCE
NAILING FLANGE
PAGE 12