Table of Contents
Advertisement
STAND-OFF ASSEMBLY & INSTALLATION
IMPORTANT: THE TOP STAND-OFF BRACKETS MUST BE FORMED AND AT-
TACHED PRIOR TO POSITIONING THE FIREPLACE INTO FRAMED OPENING.
The top stand-off brackets are attached to the fireplace top in a flat state for shipping.
1.
Remove and save the (4) screws securing stand-off heat shield and stand-off brackets.
2.
Remove (4) screws located under stand-off brackets.
3.
Form each stand-off bracket as shown.
4.
Re-attach stand-off brackets to fireplace using screws previously removed.
STAND-OFF BRACKETS
AS SHIPPED
WARNING: NON-COMBUSTIBLE ZONE:
STAND-OFFS PROVIDE THE 10" (254 mm) MINI-
MUM CLEARANCE TO HEADER. USE ONLY NON-
COMBUSTIBLE MATERIAL IN THIS AREA FOR
THE ENTIRE WIDTH OF FIREPLACE. DO NOT USE WOOD,
SHEETROCK ETC. IN THIS ZONE.
NOTE: OTHER CLEARANCES MUST BE MAIN-
TAINED. REFER TO PAGE 14 FOR MORE INFOR-
MATION.
PREPARE THE FIREPLACE
REMOVE SCREWS SECURING
EACH STAND-OFF BRACKET
FORM STAND-OFF BY BENDING
AT PERFORATIONS AS SHOWN
ATTACH BOTH STAND-OFF BRACKETS BY
ALIGNING WITH HOLES IN FIREPLACE TOP.
SECURE WITH (4) SCREWS AS SHOWN.
CAUTION: NEVER PERMANENTLY REMOVE THESE
ASSEMBLIES FROM THE FIREPLACE - THEY MUST BE
SECURED IN PLACE REGARDLESS OF FINISH MATE-
RIAL USED.
PAGE 9
CAUTION:
STAND-OFF BRACKETS ARE
NOT LOAD BEARING.
FORMED STAND-OFF
STAND-OFF BRACKETS
INSTALLED
Advertisement
Table of Contents
Troubleshooting
