Components List; Installation Overview; Placement Clearance Requirements - kozy heat DASSEL DSL-36 Installation And Operation Manual

MODEL #DSL -DASSEL COMPONENTS LIST
(#DSL-770) - Millivolt Board Assembly with 18" Flexible Gas Line attached
(#700-203) - Manual Gas Shut-off Valve
(#DSL-135) - Burner / Log Grate Assembly
(#DSL-500) - Log Package with „Klinkers‟ and Rock Wool Embers
(#DSL-057T) - Glass Frame Assembly
(#OCK-S53A) - LP Conversion Kit
(#600-083) - Receptacle / Speed Control Assembly with (3) Wire Nuts
(#942085) - 5" Restrictor Plate
(#DSL-HHS) - Horizontal Vent Heat Shield
(#500-DSL) - Grill Assembly: Upper Hood, Upper Louver and Lower Grill

INSTALLATION OVERVIEW

1. Frame an opening for the fireplace, allowing for vent installation and type of installation (corner or flat wall application).
2. If masonry (optional) will be used, prepare foundation for the masonry load. A lintel is required to support the added
weight above the fireplace.
3. Attach stand-off brackets and nailing flanges to fireplace.
4. Insert fireplace into framing.
5. Install the hearth (if applicable).
6. Complete the gas line installation.
7. Complete the electrical hook-up. Install any standard or optional electrical components at this time.
8. Complete the venting installation.
9. Secure fireplace to flooring through holes located in the outer box bottom and to framing with nailing flanges. Verify all
clearances at this point.
10. Install facing material, mantel or cabinetry, allowing room for optional full face doors, if applicable.
11. Install logs.
12. Install grills and optional decorative doors / faces.
13. Verify proper operation of fireplace and all components.

PLACEMENT CLEARANCE REQUIREMENTS

This fireplace must be installed on a level surface capable of supporting the fireplace and venting.
Fireplace must be placed directly on wood or non-combustible surface (not linoleum or carpet) extending the entire depth
and width of fireplace.
Due to high surface temperatures, fireplace should be located out of traffic and away from furniture and draperies.
This fireplace may be installed in a bedroom.
Please be aware of the large amount of heat this fireplace will produce when determining a location.
SPECIFICATIONS
PAGE 9
NOTE: The qualified installer should
follow the procedure best suited for
the installation.