Prepare The Fireplace; Nailing Flange Assembly And Installation; Glass Frame Assembly Removal; Glass Frame Assembly Installation - kozy heat Windim-WDM 56101 Installation And Operation Manual

NAILING FLANGE ASSEMBLY & INSTALLATION
1. Remove the (4) nailing flanges from fireplace sides.
2. With the 1/4" (6 mm) stand-offs on the nailing flanges facing away from fireplace, align nailing flange with the holes on the outside
corners of fireplace . Secure with screws (provided in installation manual parts packet) through the slots in the nailing flanges.
3. Bend perforation on nailing flange until parallel with fireplace face. Do not bend toward fireplace face.
4. Position framing stud against the 1/4" (6 mm) stand-off located on the backside of the nailing flange and secure with nails or screws.
NOTE: Depending on facing material, tabs can be adjusted
forward or back up to 1/2" (13 mm).
1/4" (6mm) CLEARANCE
FRONT VIEW
NAILING FLANGE
FRAMING STUD
CAUTION: NEVER PERMANENTLY REMOVE THESE ASSEMBLIES FROM THE FIREPLACE - THEY MUST BE SECURED IN PLACE REGARDLESS
OF FINISH MATERIAL USED.
REMOVE GLASS FRAME ASSEMBLY
The upper grill must be removed and the lower grill opened prior to removing glass frame assembly.
A. Locate the spring-loaded handles securing glass frame assembly at the bottom of firebox.
B. Pull bottom handles out and „down‟ to release glass frame assembly bottom.
C. Pull bottom of glass frame assembly out and lift up off tabs at top of firebox.
INSTALL GLASS FRAME ASSEMBLY
A. Place glass frame assembly top over tabs at top of firebox.
B. Pull bottom handles out and „up‟ to secure glass frame assembly bottom.

PREPARE THE FIREPLACE

1/4" (6mm)
CLEARANCE
NAILING FLANGE
TOP VIEW
STAND-OFF
FRAMING STUD
PAGE 12
WARNING: DO NOT OPERATE THIS FIRE-
PLACE WITH THE GLASS REMOVED,
CRACKED OR BROKEN. REPLACEMENT
OF GLASS ASSEMBLY, #700-07T
SHOULD BE DONE BY A LICENSED OR
QUALIFIED SERVICE PERSON.
WARNING: DO NOT REMOVE GLASS
ASSEMBLY WHEN HOT!