Log Installation - kozy heat Two Harbors 55616 Installation And Operating Manual

LOG INSTALLATION

This TWO-500 log set includes 5 logs & 1 pkg. rockwool burning embers. The logs are numbered on the bottom side - refer to the
instructions below for proper placement.
1. Position base log #1 onto the burner, aligning the notched
out section in the bottom center of the log over the pilot shield
as shown in Figure 15A.
COVER THE PORT HOLES ON THE BURNER.
2. Re-position the ember refractory panel, if necessary, at the
front of the burner as shown in Figure 15A.
3. Brush rockwool burning embers onto the burner as shown in
Figure 15B.
NOTE: You will not use all the rockwool embers at this
time. Save for future use.
4. Place top logs #2 & #3 into position over the base logs and
ember refractory panel as shown in Figure 15C.
5. Place the #4 logs into position on the ember refractory panel
as shown in Figure 15C.
DO NOT ALLOW THE LOGS TO
Ember refractory
Rockwool embers
Figure 15B Rockwool burning embers
#4
Page 16
#1
Figure 15A
#3
#2
#4
Figure 15C