Fan Installation - kozy heat Two Harbors 55616 Installation And Operating Manual

FAN KIT #TH-028 INSTALLATION INSTRUCTIONS
I
NSTALLATION OF THIS FAN SHOULD BE DONE ONLY BY A QUALIFIED INSTALLER
IMPORTANT: If a fan is going to be installed, it is easier to complete before the millivolt board is connected to the gas line.
The wiring must be done prior to enclosing the sides of the fireplace.
NOTE: An electrical box & romex connector are installed on the right side of the fireplace at the factory. The receptacle / speed
control assembly, mounting screws, and (3) wire nuts are included in the fireplace components packet.
This optional fan kit #TH-028 includes: (1) Fan assembly with temperature control switch pre-wired into the fan cord.
NOTE: Code approved line voltage wiring 14 gauge or better must be used when wiring this system. Refer to your local electrical
codes for specific requirements in your area.
WARNING: This appliance is equipped with a three-prong (grounding) plug for protection against shock hazard and should be plugged
directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.
FIGURE 12
Page 12