Thermostat - Wall Switch - Remote Control Installation - kozy heat Two Harbors 55616 Installation And Operating Manual

THERMOSTAT - WALL SWITCH - REMOTE INSTALLATION (OPTIONAL).
CAUTION: DO NOT CONNECT HIGH VOLTAGE (115V) WIRE TO THE GAS VALVE!
If desired, a thermostat (wireless style available), wall switch, or
remote control assembly may be used to turn the fireplace 'OFF'
and 'ON'. ONLY ONE of these may be installed. Follow
instructions included with each assembly.
OPTIONAL: Disconnect the on/off rocker switch wires from the
top & bottom terminals on the gas valve.
NOTE: INSTALLATION OF A THERMOSTAT OR WALL SWITCH
SHOULD ONLY BE DONE BY A QUALIFIED INSTALLER.
WALL SWITCH / THERMOSTAT USERS:
Run low-voltage (thermostat) wires from the terminals on the gas
valve to the desired location of the wall switch or thermostat.
Attach the appropriate connector to each wall switch / thermostat
wire and connect to the top and bottom terminals on the gas
valve marked 'TH'.
REMOTE CONTROL USERS:
Follow instructions included with the remote control.
IMPORTANT: The insulated cover included with the remote
control must be placed over the remote receiver to protect it
from overheating.
Remote Control Wiring Diagram
Figure 17
Thermostat Wiring Diagram
Figure 16
IMPORTANT: If the ON/OFF rocker switch wires are not
disconnected, the ON/OFF rocker switch on the millivolt board
must be in the 'OFF' position for proper operation of any of these
components.
If the rocker switch is 'ON', the fireplace burner will operate until
it is turned 'OFF' by the rocker switch. A wall switch, thermostat,
or remote control will not turn the fireplace 'OFF' when it has
been turned 'ON' by the rocker switch.
NOTE: The fireplace must be turned 'ON' and 'OFF' by the same
method. For example: If the fireplace is turned 'ON' by the
remote control, it must be turned 'OFF' by the remote control.
Page 17