Complete The Installation - kozy heat Two Harbors 55616 Installation And Operating Manual

COMPLETE THE INSTALLATION

1. A) If not previously done, plumb, level and secure the fireplace to the framing using the stud tabs located on the sides of the
unit. The stud-tabs are adjustable to accommodate the thickness of finish material you are using. To adjust, loosen the
screws securing it to the sides of the fireplace and slide to desired position. Re-tighten the screws to secure in place.
CAUTION: NEVER PERMANENTLY REMOVE THIS ASSEMBLY FROM THE FIREPLACE - IT MUST BE
SECURED IN PLACE REGARDLESS OF FINISH MATERIAL USED.
B) Use screws (not provided) to secure the fireplace to the flooring through the holes located in the bottom of the outer box.
IMPORTANT - MOBILE HOME INSTALLATIONS: THE FIREPLACE MUST BE SECURED TO THE FLOOR.
C) Complete the fireplace walls, and the fireplace facing. If tile or marble is used around or over the face of the fireplace, we
recommend using rock board as a backer.
COLD AIR TRANSFER:
2. THIS STEP SHOULD ONLY BE DONE BY A QUALIFIED INSTALLER OR SERVICE TECHNICIAN:
A) Perform lighting and shutdown procedures as described on pages #19-#20. This should be done prior to replacing the glass so
that any necessary adjustments can be made and proper operation verified.
3. Replace the glass.
A) Place the glass assembly onto the front of the fireplace and secure with the spring-loaded handles FIRST AT THE TOP, THEN AT
THE BOTTOM of the firebox. CAUTION: TO PREVENT THE GLASS ASSEMBLY FROM FALLING OFF WHEN INSTALLING ON THE
FIREPLACE, SECURE THE TOP GLASS LATCH BRACKET FIRST, THEN THE BOTTOM.
WARNING: DO NOT OPERATE THIS FIREPLACE WITH THE GLASS ASSEMBLY REMOVED, CRACKED OR
BROKEN. Replacement of the glass assembly, part #TWO-015T should be done by a licensed
or qualified service person.
4. Install the full door face:
:
MOUNTING SLOTS
Figure 18
The surrounding wood chase of the outside wall must be insulated to prevent cold
air from entering the room.
MOUNTING NUTS
1. Remove the glass frame assembly.
2. Align the (4) slots in the full door face frame to the (4)
mounting nuts along the inside frame of the fireplace.
3. Partially thread the (4) truss head screws, included with
the full door face, through the slots in the full door face
frame and into the mounting nuts.
4. Push the full door face frame back so it is against the
finish material. Tighten screws.
5. Complete installation of this full door assembly by
following the instructions included with the full door
assembly.
Page 18