Safety Requirements / Specifications - kozy heat Two Harbors 55616 Installation And Operating Manual

READ THIS MANUAL BEFORE INSTALLING AND USING THIS FIREPLACE
MODEL #55616 'Two Harbors' DIRECT VENT GAS FIREPLACE
This fireplace has been tested to and complies with ANSI Z21.88B-2003
by OMNI-Test Laboratories, Beaverton, OR. Installation must conform with local building codes or in the absence of local building
codes, with the National Fuel Gas Code, ANSI Z223.1/ NFPA 54 - Current Edition, or the Natural or Propane Installation Code, CSA
B149.1.
COMMONWEALTH OF MASSACHUSETTS
INSTALLATIONS
WARNING: This Product Must Be Installed By A Licensed
Plumber Or Gas Fitter When Installed Within The
Commonwealth of Massachusetts.
IMPORTANT: Installation of a CO detector is required in
the fireplace room.
WARNING: Do not use this fireplace if any part has been
under water. Immediately call a qualified service technician
to inspect this appliance and to replace any part of the
control system and any gas control which has been under
water.
INSPECT THE FIREPLACE & ALL COMPONENTS
Inspect the fireplace, vent system & all components. Contact your dealer if any parts are damaged or missing. Do not
install the fireplace with damaged, incomplete, or substitute parts.
PLANNING THE INSTALLATION
Prior to installation of this fireplace, the following must be considered:
‚ Location of fireplace.
Configuration of vent system.
‚
Gas piping.
‚
‚ Electrical wiring (for optional fan).
‚ Framing.
‚ Hearth height, width & depth. NOTE: A hearth is not required.
‚ Materials used for finishing the fireplace.
Optional accessories used: Fan, wall switch, remote control, thermostat, etc..
‚
NOTE: When the unit is installed directly on carpeting, tile, or other combustible materials other than wood flooring, it must be
installed on a metal or wood panel extending the full width and depth of the unit.
If masonry is to be used (optional), prepare the necessary foundation for the masonry load. When masonry construction is being
used, a lintel must be used over the top of the unit to support the added weight.
IMPORTANT:
CSA 2.33B-2003 "VENTED GAS FIREPLACE HEATERS"

DO NOT REPLACE THIS BURNER UNIT WITH ANY
OTHER SIZED BURNER. REPLACEMENT WITH AN
UNAUTHORIZED
TEMPERATURES EXCEEDING THE LIMITS FOR THIS
UNIT, AND VOID YOUR WARRANTY.
IMPORTANT: NON-COMBUSTIBLE FACING MATERIAL
MAY BE APPLIED OVER THE FACE. TO PREVENT THE
FACING MATERIAL FROM CRACKING AND FALLING
OFF DUE TO EXPANSION OF THE FACE WHEN
HEATED, DO NOT ATTACH FACING MATERIAL
DIRECTLY TO THE FACE OF THE UNIT.
OBSTRUCT THE FLOW OF VENTILATION AIR.
CONSULT YOUR LOCAL OR NATIONAL INSTALLATION
CODES TO ASSURE THAT ADEQUATE COMBUSTION
AND VENTILATION AIR IS AVAILABLE.
Page 1
WARNING:
BURNER CAN RESULT IN
DO NOT