Phone Setup Options - Cisco 7975G Software Manual

Phone Setup Options

• Press the Cancel softkey before you press the Save softkey to discard any changes that you have made.
Note The Cisco Unified IP Phone provides several methods you can use to reset or restore option settings, if
necessary. For more information, see
Related Topics
Display Settings Menu, on page 62
Unlock and Lock Options, on page 63
Phone Setup Options, on page 64
Network Configuration Menu, on page 66
Device Configuration Menu, on page 85
Security Configuration Menu, on page 109
Phone Setup Options
The settings that you can change on a phone fall into several categories, as shown in the following table. For
a detailed explanation of each setting and instructions for changing them, see
on page
Note Several options on various configuration menus are for display only, or you can configure these options
from Cisco Unified Communications Manager. This chapter also describes these options.
Table 10: Settings Configurable from the Phone
Category
General Network Settings
VLAN settings
Port settings
IPv4 Network Settings
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
64
66.
Description
Admin. VLAN ID allows you to change
the administrative VLAN used by the
phone. PC VLAN allows the phone to
interoperate with third-party switches that
do not support a voice VLAN.
Allow you to set the speed and duplex of
the network and access ports.
Cisco Unified IP Phone Reset or Restore, on page
Network Configuration menu option
Admin. VLAN ID
PC VLAN
SW Port Configuration
PC Port Configuration
Cisco Unified IP Phone Settings
234.
Network Configuration Menu,