Cisco 7975G Software Manual page 230

Streaming Statistics
To display a Streaming Statistics area, access the web page for the phone as described in
for Phone, on page
IP Phones 7975G, 7965G, and 7945G also include Stream 4 and Stream 5 hyperlinks).
The following table describes the items in the Streaming Statistics areas.
Table 52: Streaming Statistics Area Items
Item
Remote Address
Local Address
Start Time
Stream Status
Host Name
Sender Packets
Sender Octets
Sender Codec
Sender Reports Sent
(See Note)
Sender Report Time Sent
(See Note)
Rcvr Lost Packets
Avg Jitter
Rcvr Codec
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
210
198, and then click the Stream 1, the Stream 2, or the Stream 3 hyperlink (Cisco Unified
Description
IP address and UDP port of the destination of the stream.
IP address and UPD port of the phone.
Internal time stamp indicating when Cisco Unified Communications
Manager requested that the phone start transmitting packets.
Indication of whether streaming is active.
Unique, fixed name that is automatically assigned to the phone based on
its MAC address.
Total number of RTP data packets transmitted by the phone since starting
this connection. The value is 0 if the connection is set to receive only
mode.
Total number of payload octets transmitted in RTP data packets by the
phone since starting this connection. The value is 0 if the connection is
set to receive only mode.
Type of audio encoding used for the transmitted stream.
Number of times the RTCP Sender Reports have been sent.
Internal time stamp indicating when a RTCP Sender Report was sent.
Total number of RTP data packets that have been lost since starting
receiving data on this connection. Defined as the number of expected
packets less the number of packets actually received, where the number
of received packets includes any that are late or duplicate. The value
displays as 0 if the connection was set to send-only mode.
Estimate of mean deviation of the RTP data packet inter-arrival time,
measured in milliseconds. The value displays as 0 if the connection was
set to send-only mode.
Type of audio encoding used for the received stream.
Remote Monitoring
Access Web Page