Cisco 7975G Software Manual page 178

EnergyWise Setup on Cisco Unified IP Phone
The following table explains the Cisco Unified Communications Manager Administration fields that control
the EnergyWise settings. You configure these fields in Cisco Unified Communications Manager Administration
by choosing Device > Phone. You can also configure EnergyWise parameters in the Enterprise Phone
Configuration and Common Phone Profile Configuration windows.
Table 39: EnergyWise Configuration Fields
Field
Enable Power Save Plus
Phone On Time
Phone Off Time
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
158
Description
Selects the schedule of days for which the phone powers off. Select
multiple days by pressing and holding the Control key while clicking
on the days for the schedule.
By default, no days are selected.
When Enable Power Save is checked, you receive a message to warn
about emergency (e911) concerns.
While Power Save Plus mode (hereafter, the mode) is in
Caution
effect, endpoints configured for the mode are disabled for
emergency calling and from receiving inbound calls. By
selecting this mode, you agree to the following: (i) you are
taking full responsibility for providing alternate methods
for emergency calling and receiving calls while the mode
is in effect; (ii) Cisco has no liability in connection with
your selection of the mode and all liability in connection
with enabling the mode is your responsibility; and (iii) you
will inform users of the effects of the mode on calls, calling
and otherwise.
To disable Power Save Plus, you must uncheck the Allow
Note
EnergyWise Overrides check box. Leaving the Allow
EnergyWise Overrides checked with no days selected in the
Enable Power Save Plus field does not disable Power Save
Plus.
Determines when the phone automatically turns on for the days selected
in the Enable Power Save Plus field.
Enter the time in this field in 24 hour format, where 00:00 is midnight.
For example, to automatically power up the phone at 7:00 a.m. (0700),
enter 7:00. To power up the phone at 2:00 p.m. (1400), enter 14:00.
The default value is blank, which means 00:00.
The time of day that the phone powers down for the days selected in
the Enable Power Save Plus field. If the Phone On Time and the Phone
Off Time fields contain the same value, the phone does not power
down.
Enter the time in this field in 24 hour format, where 00:00 is midnight.
For example, to automatically power down the phone at 7:00 a.m.
(0700), enter 7:00. To power down the phone at 2:00 p.m. (1400),
enter 14:00.
The default value is blank, which means 00:00.
Features, Templates, Services, and Users