Status Messages - Cisco 7975G Software Manual

Status Messages Screen
Procedure
Step 1 Press Settings.
Step 2 Select Status.
Step 3 Select Status Messages.
Step 4
To remove current status messages, press Clear.
Step 5 To exit the Status Messages screen, press Exit.

Status Messages

Table 43: Status Messages on the Cisco Unified IP Phone
Message
BootP server used
CFG file not found
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
178
Description
The phone obtained its IP address
from a BootP server rather than a
DHCP server.
The name-based and default
configuration file was not found on
the TFTP Server.
Model Information, Status, and Statistics
Possible explanation and action
None. This message is informational only.
Cisco Unified Communications Manager
creates a configuration file for the phone
with the phone is added to the database. If
the phone has not been added to the
Cisco Unified Communications Manager
database, the TFTP server generates a CFG
File Not Found response.
• Phone is not registered with
Cisco Unified Communications
Manager.
You must manually add the phone to
Cisco Unified Communications
Manager if you are not allowing
phones to autoregister. See
Unified Communications Manager
Administration Phone Addition, on
page 39 for details.
• If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
• If you are using static IP addresses,
check configuration of the TFTP
server. See Network Configuration
Menu, on page 66 for details on
assigning a TFTP server.
Cisco