Cisco 7975G Software Manual page 117

Cisco Unified IP Phone Settings
Option
Recording Tone
Recording Tone
Local Volume
Description
Indicates whether a recording tone
(often referred to as a beep tone) is
enabled or disabled for the phone.
If the recording tone option is
enabled, the phone plays the beep
tone in both directions of every call,
regardless of whether the call
actually gets recorded. The beep
tone first sounds when a call is
answered.
You may want to notify your users
if you enable this option.
Default: Disabled
Related Parameters:
• Recording Tone Local
Volume
• Recording Tone Remote
Volume
• Recording Tone Duration
Other related parameters—Beep
tone frequency in Hz, the length of
the beep tone (called duration), and
how often the beep tone plays
(called interval)—are defined on a
per-Network Locale basis in the
xml file that defines tones. This xml
file is usually named tones.xml or
g3-tones.xml.
Indicates the loudness setting for
the beep tone that is received by the
party whose phone has the
Recording Tone option enabled.
This setting applies for each
listening device (handset,
speakerphone, headset).
Range: 0 percent (no tone) to 100
percent (same level as current
volume setting on the phone).
Default: 100
See also Recording Tone in this
table.
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Media Configuration Menu
To change
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Communications Manager 9.0 (SCCP and SIP)
97