Start/Stop From The Operation Panel (Pu Operation Mode); Set The Set Frequency To Operate (Example: Performing Operation At 30Hz) - Mitsubishi Electric FR-A701 Instrucion Manual

4.4 Start/stop from the operation panel (PU operation mode)

POINT
From where is the frequency command given?
· Operation at the frequency set in the frequency setting
mode of the operation panel
→Refer to 4.4.1 (Refer to page 83)
· Operation using the setting dial as the potentiometer
→Refer to 4.4.2 (Refer to page 84)
· Change of frequency with ON/OFF switches connected
to terminals →Refer to 4.4.3 (Refer to page 85)
· Frequency setting with a voltage output device
→Refer to 4.4.4 (Refer to page 86)
· Frequency setting with a current output device
→Refer to 4.4.5 (Refer to page 87)
4.4.1

Set the set frequency to operate (example: performing operation at 30Hz)

Operation
1.
Screen at powering on
The monitor display appears.
2.
Press to choose PU
operation mode.
3.
Turn to show the frequency
you want to set.
The frequency flickers for about 5s.
4.
While the value is flickering,
press to set the frequency.
If you do not press
and the display then returns to 0.00 (display) Hz.
At this time, return to "Step 3" and set the frequency again.
5.
After the value flickered for about 3s,
the display returns to 0.00 (monitor display).
Press (or
6.
To change the set frequency, perform the
operation in above steps 3 and 4.
(Starts from the previously set frequency.)
7.
Press to stop.
Operation cannot be performed at the set frequency ... Why?
Did you carry out step 4 within 5s after step 3? (Did you press
The frequency does not change by turning
Check to see if the operation mode selected is external operation mode. (Press
operation mode.)
Operation does not change to the PU operation mode ... Why?
Check that "0" (initial value) is set in Pr. 79 Operation mode selection.
Check that the start command is not on.
Change acceleration time
Change deceleration time
For example, limit the motor speed to 60Hz maximum.
REMARKS
· Press to show the set frequency.
· can also be used like a potentiometer to perform operation. (Refer to page 84)
, the value flickers for about 5s
) to start operation.
Pr. 7 (Refer to page 61)
Pr. 8 (Refer to page 61)
Start/stop from the operation panel (PU
[Connection diagram]
Three-phase
AC power supply
Display
PU indication is lit.
Flicker ··· Frequency setting complete!!
3s later
( )
... Why?
Set "60Hz" in Pr. 1. (Refer to page 60)
operation mode)
Inverter
R/L1 U
S/L2 V
T/L3 W
FR-DU07
,
,
Flickers for
about 5s
within 5s after turning ?)
to change to PU
Motor
4
83