Start/stop from the operation panel (PU
operation mode)
4.4.2
Use the setting dial like a potentiometer to perform operation.
POINT
Set "1" (setting dial potentiometer mode) in Pr. 161 Frequency setting/key lock operation selection.
Operation example Change the frequency from 0Hz to 60Hz during operation
1.
Screen at powering on
The monitor display appears.
2.
Press
3.
Change Pr. 161 to the setting value "
(Refer to page 52 for change of the setting.)
4.
Press
5.
Turn
The flickering frequency is the set frequency.
You need not press
REMARKS
· If flickering "60.00" turns to "0.0", the Pr. 161 Frequency setting/key lock operation selection setting may not be "1".
· Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning
84
Operation
to choose PU operation mode.
".
(or
) to start the inverter.
until "
" appears.
60.00
.
Display
PU indication is lit.
The frequency flickers for about 5s.
.