Pu Operation Mode (Operation Using The Operation Panel (Fr-Du04)) - Mitsubishi Electric FR-F500 Series Instruction Manual

3.4.3 PU operation mode
(Operation using the operation panel (FR-DU04))
( 1 ) Operation at 60Hz
While the motor is running, repeat the following steps 2 and 3 to vary the speed:
Step
Power-on → Operation mode check
Switch power on and make sure that the operation command indication "PU" is lit.
(If it is not lit, press the
1 key to switch to PU operation. For operation mode changing, refer to page
51.)
Running frequency setting
Set the running frequency to 60Hz.
First, press the
MODE
2
key to change the setting, and press the
Start
Press the or
FWD REV
The motor starts running. The monitoring mode is automatically selected and the
output frequency is displayed.
3
Stop
STOP
Press the
RESET
The motor is decelerated to a stop.
4
( 2 ) PU jog operation
Hold down the or
REV
FWD
1) Set Pr. 15 "jog frequency" and Pr. 16 "jog acceleration/deceleration time".
2) Select the PU jog operation. (Press the
to switch to PU JOG operation.)
3) Hold down the or
FWD
(If the motor remains stopped, check Pr. 13 "starting frequency". The motor will not start if its setting is
lower than the starting frequency.)
Description
key to choose the operation mode and press the
MODE
key to select the frequency setting mode. Then, press the
key.
key.
key to perform operation, and release it to stop.
key to choose the operation mode and press the
MODE
key to perform operation.
REV
OPERATION/CONTROL
key to write the frequency.
SET
60
Image
ON
FR-DU04
CONTROL PANEL
MON EXT PU
REV FWD
(or)
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
(or)
FWD REV
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
key
3