Download  Print this page

Inverter Generates Abnormal Noise; Motor Generates Heat Abnormally; Motor Rotates In Opposite Direction; Speed Greatly Differs From The Setting - Mitsubishi Electric FR-A701 Instrucion Manual

Hide thumbs

Advertisement

Check first when you have troubles

5.6.3 Inverter generates abnormal noise.

Check that a fan cover is correctly reinstalled when replacing a cooling fan.
An AC reactor is built-in and a greater noise than at driving is produced during regeneration operation. But it
is not a fault.

5.6.4 Motor generates heat abnormally

Is the fan for the motor is running? (Check for accumulated dust.)
Check that the load is not too heavy. Lighten the load.
Check that the inverter output voltages (U, V, W) balanced.
Check that the Pr. 0 Torque boost setting is correct.
Was the motor type set? Check the setting of Pr. 71 Applied motor.
When using any other manufacturer's motor, perform offline auto tuning. (Refer to page 71.)

5.6.5 Motor rotates in opposite direction

Check that the phase sequence of output terminals U, V and W is correct.
Check that the start signals (forward rotation, reverse rotation) are connected properly. (Refer to page 88)

5.6.6 Speed greatly differs from the setting

Check that the frequency setting signal is correct. (Measure the input signal level.)
Check that the Pr. 1, Pr. 2, Pr. 19, Calibration parameter C2 to C7 settings are correct.
Check that the input signal lines are not affected by external noise.
(Use shielded cables)
Check that the load is not too heavy.
Check that the Pr. 31 to Pr. 36 (frequency jump) settings are correct.

5.6.7 Acceleration/deceleration is not smooth

Check that the acceleration and deceleration time settings are not too short.
Check that the load is not too heavy.
Check that the torque boost (Pr. 0, Pr. 46, Pr. 112) setting is not too large and the stall prevention function is
not activated under V/F control.

5.6.8 Motor current is large

Check that the load is not too heavy.
Check that the Pr. 0 Torque boost setting is appropriate.
Check that the Pr. 3 Base frequency setting is appropriate.
Check that the Pr. 14 Load pattern selection setting is appropriate.
Check that the Pr. 19 Base frequency voltage setting is appropriate.

5.6.9 Speed does not increase

Check that the maximum frequency (Pr. 1) setting is correct. (If you want to run the motor at 120Hz or more,
set Pr. 18 High speed maximum frequency. (Refer to chapter 4 of
Check that the load is not too heavy.
(In agitators, etc., load may become heavier in winter.)
Check that the torque boost (Pr. 0, Pr. 46, Pr. 112) setting is not too large and the stall prevention function is
not activated under V/F control.

5.6.10 The motor and machine vibrate.

Set Pr. 19 Base frequency voltage to the rated motor voltage under V/F control.
Check for any mechanical looseness.
160
the instruction manual (applied).))

Advertisement

Table of Contents

   Also See for Mitsubishi Electric FR-A701

   Related Manuals for Mitsubishi Electric FR-A701

Comments to this Manuals

Symbols: 0
Latest comments: