Download  Print this page

Start/stop From The Operation Panel (pu Operation); Set The Set Frequency To Operate (example: Performing Operation At 30hz) - Mitsubishi Electric FR-E700 Basic Instruction Manual

Hide thumbs

Advertisement

3.4

Start/stop from the operation panel (PU operation)

POINT
From where is the frequency command given?
Operation at the frequency set in the frequency setting mode of the operation panel
(Refer to page 55)
Operation using the setting dial as the potentiometer
Change of frequency with ON/OFF switches connected to terminals
Perform frequency setting using voltage input signal
Perform frequency setting using current input signal
3.4.1

Set the set frequency to operate (example: performing operation at 30Hz)

Operation
1.
Screen at powering ON
The monitor display appears.
2.
Press
to choose the PU operation mode.
3.
Turn
to show the frequency you want to
set.
The frequency flickers for about 5s.
4.
While the value is flickering, press
the frequency.
(If you do not press
about 5s and the display then returns to
"
" (0.00Hz.). At this time, return to "Step
3" and set the frequency again.
5.
After the value flickered for about 3s, the
display returns to "
Press
to start operation.
6.
To change the set frequency, perform the
operation in above steps 3 and 4.
(Starting from the previously set frequency.)
7.
Press
to stop.
Start/stop from the operation panel (PU operation)
[Connection diagram]
Inverter
R/L1
Three-phase AC
S/L2
power supply
T/L3
Operation panel
,
to set
, the value flickers for
Flicker...frequency setting complete!!
" (monitor display).
refer to 3.4.2 (Refer to page 57)
refer to 3.4.3 (Refer to page 58)
refer to 3.4.4 (Refer to page 59)
refer to 3.4.5 (Refer to page 60)
U
V
Motor
W
,
Display
PU indication is lit.
Flickers for about 5s
3s later
refer to 3.4.1
3
55

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric FR-E700

   Related Content for Mitsubishi Electric FR-E700

This manual is also suitable for:

Fr-e720-0.1kFr-e740-0.4kFr-e720s-0.1kFr-e710w-0.1k

Comments to this Manuals

Symbols: 0
Latest comments: