Download  Print this page

Advertisement

Make a start and stop with terminals

(external operation)

[EXT] is not lit even when
Switchover of the operation mode with
50Hz, 30Hz and 10Hz are not output from RH, RM and RL respectively when they are turned on. ... Why?
Check for the setting of Pr. 4, Pr. 5, and Pr. 6 once again.
Check for the setting of Pr. 1 Maximum frequency and Pr. 2 Minimum frequency once again. (Refer to
page 60)
Check for the Pr. 79 setting once again. (Pr. 79 must be set to "0" or "2".) (Refer to page 62)
Check that Pr. 180 RL terminal function selection = "0", Pr. 181 RM terminal function selection = "1",
Pr. 182 RH terminal function selection = "2" and Pr. 59 Remote function selection = "0". (all are initial
values)
[FWD (or REV)] is not lit. ... Why?
Check that wiring is correct. Check it again.
Check that "60" is set in Pr. 178 STF terminal function selection (or "61" is set in Pr. 179 STR terminal
function selection)?
(all are initial values)
How is the frequency setting from 4 to 7 speed ?
The setting differs according to Pr. 24 to Pr. 27 (multi-speed setting). Refer to chapter 4 of
instruction manual (applied).
Perform multi-speed operation higher than 8 speed. ... How?
Use the REX signal to perform the operation. Refer to chapter 4 of
(applied).
REMARKS
· External operation is fixed by setting "2" (external operation mode) in Pr. 79 Operation mode selection when you do not want to take
time pressing
or when you want to use the current start command and frequency command. (Refer to page 62)
90
is pressed ... Why?
is valid when Pr. 79 = "0" (initial value).
the
the instruction manual

Advertisement

Table of Contents

   Also See for Mitsubishi Electric FR-A701

   Related Manuals for Mitsubishi Electric FR-A701

   Related Content for Mitsubishi Electric FR-A701

Comments to this Manuals

Symbols: 0
Latest comments: