Long Wave Sfp+ Modules (16Gbit/S) Installation Procedure - Fujitsu ETERNUS DX100 S3 Operation Manual

Chapter 5 Expansion Functions
5.3 Installing Long Wave SFP+ Modules (16Gbit/s)
●
About Static Electricity
●
About Shock
5.3.4

Long Wave SFP+ Modules (16Gbit/s) Installation Procedure

This section describes how to replace a Short wave SFP+ module (16Gbit/s) in the host interface (FC 16Gbit/s)
with a Long wave SFP+ module (16Gbit/s).
1
Check that all components of the ETERNUS DX are in normal status, using the [Storage System Status]
screen of ETERNUS Web GUI.
2
Check the port location of the Short wave SFP+ module (16Gbit/s) that is to be replaced by using the
Internal Parts information in the [Channel Adapter Detail] screen.
Note that a Short wave SFP+ module (16Gbit/s) is displayed as "16G SFP+(MMF)" in the "SFP Type" field.
3
Turn off the ETERNUS DX.
Refer to
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Do
When handling SFP+ modules, make sure to wear a wrist strap or touch a metal
•
part to discharge the human body's natural static electricity.
Failure to discharge static electricity may cause device failure.
Leave the SFP+ module in its package until ready to install it.
•
Do Not
• Do not handle SFP+ modules roughly or subject them to physical shocks when lay-
ing them down.
• Do not place any objects on top of SFP+ modules.
Do not knock or drop SFP+ modules on hard objects.
•
Do
• If SFP+ modules are installed in a way other as described here, damage and/or de-
vice failure or electrical shock may occur.
"2.1.4 Powering Off" (page 49)
Copyright 2014 FUJITSU LIMITED
for details on how to turn off the ETERNUS DX.
94
P3AM-7662-04ENZ0