Figure 1.28 I/O Module (2.5" / 3.5" Type Drive Enclosure); Table 1.7 Status And Meanings Of Each Led (I/O Module (2.5" / 3.5" Type Drive Enclosure)) - Fujitsu ETERNUS DX100 S3 Operation Manual

Chapter 1 Component Name/LED Name
1.2 2.5"/3.5" Type Drive Enclosure
Figure 1.28 shows the I/O module.

Figure 1.28 I/O Module (2.5" / 3.5" Type Drive Enclosure)

2 3
1. DI (IN) port
These ports are used to connect between enclosures.
2. DI (IN) FAULT LED
3. DI (IN) LINK LED
4. DI (OUT) port
These ports are used to connect between enclosures.
5. DI (OUT) LINK LED
6. DI (OUT) FAULT LED
7. READY LED
8. IDENTIFY LED
9. FAULT LED
The states of LEDs are listed below.

Table 1.7 Status and Meanings of Each LED (I/O Module (2.5" / 3.5" Type Drive Enclosure))

LED name
DI (IN) LINK
DI (IN) FAULT
DI (OUT) LINK
DI (OUT) FAULT
READY
IDENTIFY
FAULT
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Table 1.7
1 4 5 6
LED status
(green)
(amber)
(blinks amber)
(green)
(amber)
(blinks amber)
(green)
(blinks blue)
(amber)
Copyright 2014 FUJITSU LIMITED
shows the status and meanings of each LED.
Meaning
The link between the DI (IN) port and the source port has been
established.
The ports to remove the mini SAS HD cables between enclosures
from are indicated. This occurs while a drive enclosure is being
added.
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
The link between the DI (OUT) port and the destination port has
been established.
The link between the DI (OUT) port and the destination port is in
error status.
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
The I/O module is in normal status.
The installation location of the I/O module is identified according
to the instruction that is issued from ETERNUS Web GUI or ETER-
NUS CLI.
The I/O module is in error status.
32
7
8
9
P3AM-7662-04ENZ0