Chapter 7
Troubleshooting
7.1
Check List
3
After completing the settings, confirm that access from the server is available.
●
SAS Card Replacement
The following procedure explains how to replace the SAS card.
1
Check the SAS address, the host affinity and the other settings of the SAS card that is to be removed
from ETERNUS Web GUI or ETERNUS CLI, and then record the settings.
2
Replace the SAS card on the server.
(1)
Turn off the server where the SAS card is to be replaced.
(2)
Replace the SAS card.
For details on the replacement procedure, refer to the relevant documentation for the SAS card.
3
Change the SAS address, host affinity, and other settings of the removed SAS card.
Set the SAS address, host affinity, and other settings of the new SAS card by referring to the information
recorded in
4
After completing the settings, confirm that access from the server is available.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Step
1.
Copyright 2014 FUJITSU LIMITED
111
P3AM-7662-04ENZ0