Adding Servers; Raid Group Creation - Fujitsu ETERNUS DX100 S3 Operation Manual

Chapter 5 Expansion Functions
5.4

Adding Servers

9
Repeat Step 5
10
If a wrist strap is used, remove the wrist strap.
11
Turn on the ETERNUS DX.
Refer to
12
Check that the PORT LINK/FAULT LED for the FC port on the replaced Long wave SFP+ module (16Gbit/s)
turns off or lights up green.
13
Start ETERNUS Web GUI to check the status of the newly added Long wave SFP+ module (16Gbit/s).
On the Internal Parts information in the [Channel Adapter Details] screen of ETERNUS Web GUI, check
that the FC port status is Normal and the SFP type is changed to "16G SFP+(SMF)". In addition, confirm
that all of the other components are in normal status.
5.4 Adding Servers
To connect a new server to ETERNUS DX, preparation is required.
5.4.1

RAID Group Creation

Create RAID groups in order to create volumes to be used by the added server.
If free space in an existing RAID group is used, this procedure can be omitted.
The procedure to register a RAID group is as follows:
1
Click the [RAID Group] tab on the navigation of the ETERNUS Web GUI screen.
The [RAID Groups] screen appears.
2
In [Action], click [Create].
The [Create RAID Group] screen appears.
3
Enter the name of the RAID group that is to be registered and select "Automatic" or "Manual" for "Create
Mode".
When "Automatic" is selected, the settings for "Automatic Setting" are displayed.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Do
• When connecting the FC cables, position them so that they will not obstruct
replacement of the power supply unit or controllers by the maintenance engi-
neer.
through Step 8 to replace multiple SFP+ modules (16Gbit/s).
"2.1.3 Powering On" (page 48)
Copyright 2014 FUJITSU LIMITED
for details on how to turn on the ETERNUS DX.
96
P3AM-7662-04ENZ0