Fujitsu ETERNUS DX100 S3 Operation Manual page 71

Chapter 5 Expansion Functions
5.1 Installing Additional Drives
(3)
Swing the lock lever in the direction of the arrow, until the lock clicks shut.
(4)
Check the status of the LED on the Disk Activity Panel (DAP) of the added drive.
11
To install more additional drives, repeat
12
Close the top board.
13
Insert the high-density drive enclosure all the way into the rack while pulling the stopper catches on
both sides of the high-density drive enclosure back.
14
Push the stopper catches to lock the high-density drive enclosure.
15
Fasten the high-density drive enclosure to the rack pillar with the M4 screws that were removed in
4.
16
Attach the front cover.
17
If a wrist strap is used, remove the wrist strap.
18
In the [Drives] screen of [Component] on the ETERNUS Web GUI screen, check that the added drives
have been recognized.
19
Set up RAID groups, volumes, hot spares, and host affinity settings, as required.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Step 9 and Step 10.
71
Copyright 2014 FUJITSU LIMITED
Step
P3AM-7662-04ENZ0