Components (Rear); Figure 1.26 3.5" Drives; Figure 1.27 Drive Slot Numbers (3.5" Type Drive Enclosure); Table 1.6 Status And Meanings Of Each Led (Drive (2.5" / 3.5" Type Drive Enclosure)) - Fujitsu ETERNUS DX100 S3 Operation Manual

Chapter 1 Component Name/LED Name
1.2 2.5"/3.5" Type Drive Enclosure
●
3.5" Drives
Figure 1.26 shows the 3.5" drive.
Table 1.6 shows the status and meanings of each LED.

Figure 1.26 3.5" Drives

1. DRIVE READY LED
2. DRIVE FAULT LED

Figure 1.27 Drive Slot Numbers (3.5" Type Drive Enclosure)

The states of LEDs are listed below.

Table 1.6 Status and Meanings of Each LED (Drive (2.5" / 3.5" Type Drive Enclosure))

LED name
DRIVE READY
DRIVE FAULT
1.2.4

Components (Rear)

This section describes the I/O modules and the power supply units in the rear of the drive enclosure.
■
I/O Modules
The I/O module is a component that controls how the controller and the drives interact.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Figure 1.27
1
2
Slot#8 Slot#9
Slot#4 Slot#5
Slot#0 Slot#1
LED status
(green)
(blinks green)
(amber)
Copyright 2014 FUJITSU LIMITED
shows the slot number of each 3.5" drive.
Slot#10
Slot#6
Slot#2
Meanings
The drive is in normal status.
• The drive is in error status.
In response to commands from ETERNUS CLI, the location of
•
the drive is identified.
31
Slot#11
Slot#7
Slot#3
P3AM-7662-04ENZ0