Table of Contents
Advertisement
FibreCAT S80 Quick Installation Guide
Installation for PRIMEPOWER
Documentation / Management Tool / Settings can be retrieved from:
Internet ftp site
ftp://raid@ftp.fujitsu-siemens.com/(user: raid, Pass word: 4jumbo17)
Please be sure to have the following Microsoft Internet Explorer settings
activated:
IE: Tools => Internet options => Advanced => x Enable folder view for ftp sites
Mandatory FibreCAT S80 FFx2 Firmware is 8.57
The needed Graphic User Interface Management tool is Spheras 1.3
How to install Spheras under Solaris can be found at ftp:
FibreCAT_S80/Manuals/Spheras-Manual_e.pdf
Installation procedure
1. Install the necessary (see Support Matrix) Fibre-Channel driver lpfc (and
hbAnyware) (pkgadd ...). The driver and hbAnyware is available on the
Control-CD delivered with each Primepower.
2. Adjust the lpfc.conf settings according the Solaris documentation
(FibreCAT_S80/Manuals/ ...html)
3. Adjust the sd.conf (scan LUNs during boot)
4. Install Spheras (pkgadd ...)
5. Reboot using at lpfc.conf the settings (beside the others from above):
(Attention! delivery FC speed of FibreCAT S80 is 1 Gbit/s)
link-speed=0
topology=0
automap=2
After reboot you should see a PSEUDO LUN at EUROLOGC
via /opt/FJSVmadm/sbin/hrdconf -l
U41578-J-Z875-1-76
(mandatory for first boot)
(mandatory for first boot)
(mandatory for first boot)
77
Advertisement
Table of Contents
