Fujitsu ETERNUS DX100 S3 Operation Manual page 83

Chapter 5 Expansion Functions
5.2 Installing Additional Drive Enclosures
(4)
Install the flap brackets.
Attach flap bracket A and B on the right side of the rear rack pillar with the M4 screws.
The M4 screw positions for flap bracket A and B are determined by the high-density drive enclo-
sure base line.
Insert the M4 screws in the seventh and eighth holes above the base line to fasten the flap
brackets.
[Left]
(5)
Install the high-density drive enclosure in the rack.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Rack rail
(right)
Stopper bracket B
M4 screw
(Rack pillar: rear)
Rear view of a high-density drive enclosure
Flap bracket B
4U
High-density drive
enclosure base line
Rack rails
Do
- For safety and stability, use a lifter to install or remove high-density
drive enclosures in the rack.
Copyright 2014 FUJITSU LIMITED
(Rack pillar: front)
Rack rail
(left)
Stopper bracket A
[Right]
7th & 8th
holes
(M5 screws)
83
P3AM-7662-04ENZ0