Fujitsu ETERNUS DX100 S3 Operation Manual page 80

Chapter 5 Expansion Functions
5.2 Installing Additional Drive Enclosures
(7)
Attach the flange cover.
High-density drive enclosures (for regions other than EMEA&I)
•
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Pull the rail lock lever in the direction of the arrow and unlock it to adjust the length of the rack
rails to match the distance between the front and the rear rack pillars. Leave the rail lock lever
unlocked because the rail lock lever is locked after the rack rail is installed.
(Rack pillar: front)
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Rail lock lever
Unlock the levers to adjust the length of the
rack rails to match the distance between the
front and rear rack pillars.
[Left]
[Right]
80
Copyright 2014 FUJITSU LIMITED
Rack rail (left)
"Left" is on the exterior
Rack rail (right)
"Right" is on the exterior
(Rack pillar: rear)
P3AM-7662-04ENZ0