Fujitsu ETERNUS DX100 S3 Operation Manual page 99

Chapter 5 Expansion Functions
5.4 Adding Servers
■
CA Port Parameter Settings
Set the CA port parameters if the port information of the ETERNUS DX needs to be changed because of the
server that is to be added.
When any server is already connected, make sure that the server will not be affected by the change.
For details on how to change the settings, refer to "Configuration Guide (Web GUI)".
■
CA Port Group Creation
Create a CA port group for a host to access the ETERNUS DX.
A CA port group is a group of host interface ports that have the same interface and connect to the specific
host group.
The procedure to create a CA port group is as follows:
1
Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen, and then click "Port
Group" in [Category].
The [CA Port Group] screen appears.
2
In [Action], click the [Create CA Port Group] that corresponds to the host interface of the port group that
is to be added.
The [Create CA Port Group] screen appears.
3
In the [Create CA Port Group] screen, enter the name of the CA port group that is to be created, select
the checkbox for the ports that are to be registered in the CA port group, and click the [Create] button.
A confirmation screen appears.
4
Click the [OK] button.
The CA port group is created and the setting completion screen appears.
5
Click the [Done] button.
The screen display returns to the [CA Port Group] screen.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
99
Copyright 2014 FUJITSU LIMITED
P3AM-7662-04ENZ0