Fujitsu ETERNUS DX100 S3 Operation Manual page 90

Chapter 5 Expansion Functions
5.2 Installing Additional Drive Enclosures
13
Connect the DI (OUT) port of CM#1 in the controller enclosure to the DI (IN) port of IOM#1 in the drive
enclosure that is to be added with a cable between enclosures.
The following figure shows how a cable between enclosures (CE and DE) is connected when drive enclo-
sure 2 is added.
The FAULT LED for the DI (IN) port to which the cable is to be connected and the LINK/FAULT LED for the
DI (OUT) port blink on and off.
Drive enclosure 2
(drive enclosure
that is to be added)
Drive enclosure 1
Controller enclosure
14
Click the [Next >>] button.
The [Enable IOM#1] screen appears.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Connect
here
90
Copyright 2014 FUJITSU LIMITED
Connect
here
Controller 1
P3AM-7662-04ENZ0