Table of Contents
Advertisement
20
en | Configuration and final assembly
7
Configuration and final assembly
7.1
Camera Operation
Warning!
Hazardous voltage
!
Use caution when working inside the housing. Hazardous voltage is present in the housing
when connected to the AC supply. Do not touch the power terminals when the unit is
powered.
Verify operation of the camera and lens before final assembly. If necessary, adjust the camera
orientation, focal length and focus (refer to the following configuration descriptions for analog
and IP cameras).
Other adjustments
Other minor operation adjustments are possible using the camera Menu button; these
adjustments are described in the camera Operation Guide (see Bosch website for applicable
camera).
7.2
Configuring IP camera kits
The camera normally provides an optimal picture without the need for further adjustments,
however when the kit is mounted and connected, the camera field of view and focus point
may need to be adjusted. To do this:
1.
2.
Note: For ease of connection, use the optional NBN-MCSMB-30M cable (not supplied with Kit)
to connect a monitor to the camera.
Install wizard and MENU button on camera
The MENU button on the rear panel is used for accessing the camera install wizard. The
wizard fine-tunes the focus and optimizes picture sharpness in both bright and low-level
lighting (for example, at night).
When there is a choice in the wizard, the options are selected by either a short press or a
longer press of the MENU button. Select EXIT to close the wizard.
Using Install wizard
1.
2.
3.
4.
5.
2014.11 | 1.0 | F.01U.309.609
Connect a monitor to the 'CVBS' SMB connector on the rear of the camera.
Start the install wizard.
Power-up the camera and wait briefly before opening the camera install wizard.
Briefly press Menu to start the wizard and display the following screen on the monitor:
Lens type: DC Iris
State: Ready
CONTINUE
180° ROTATE
< press short >
< press long >
The lens type is identified and shown on the screen.
The iris is opened to its maximum value.
To rotate the image 180°, press and hold Menu until the image flips.
Briefly press Menu to continue.
Briefly press Menu to center the focus.
Focus indicator: 8
Timeout: 300
Installation Manual
DINION Housing Kit
Bosch Security Systems
Advertisement
Table of Contents
