Step 3: Providing Camera Power - Basler CXP-12 Quick Install Manual

NOTICE
Damage Hazard: Inserting the lens too far into the camera may damage
the sensor.
When carrying out the next step, make sure not to insert the lens any
deeper than the specified maximum allowed lens intrusion.
For detailed information, refer to the Basler Product Documentation
available at: docs.baslerweb.com
4. Attach a suitable lens to the camera.
5. Provide sufficient heat dissipation, e.g., by attaching two heat sinks to
the camera.

Step 3: Providing Camera Power

Note: The camera can be powered via PoCXP or via the I/O connector
using an external power supply (AUX power).
If you power your camera by both the CoaXPress interface and the
I/O connector, the power provided by the I/O connector is used only.
1. If you are using PoCXP:
Plug one end of the CoaXPress cable into the Micro-BNC (HD-BNC)
connector of the camera and plug the other end of the CoaXPress cable
into the Micro-BNC connector of the interface card.
HARDWARE INSTALLATION
EN
ZH
JA
9