Table of Contents
Advertisement
CDM-800 Gateway Router
Ethernet-based Remote Product Management
5.2
Ethernet Management Interface Protocols
The user PC facilitates access to Ethernet‐based remote monitor and control (M&C) of the
CDM‐800 through two separately‐operated protocols:
•
Simple Network Management Protocol (SNMP). This requires a user‐supplied Network
Management System (NMS) and a user‐supplied Management Information Base (MIB) File
Browser.
•
The CDM‐800 Web Server (HTTP) Interface. This requires a compatible user‐supplied Web
browser such as Internet Explorer.
5.2.1 Ethernet Management Interface Access
Access to the CDM‐800 Ethernet Management Interface requires the user to specify the unit
Management IP Address. Via use of a terminal emulator connected to the rear panel 9‐pin serial
'CONSOLE' port, this address may be obtained from the CDM‐800 Serial Interface upon power‐
up of the unit. As shown, a number of operational parameters (including the unit factory‐default
IP addresses) are displayed.
The factory‐assigned default IP addresses are provided in the table that follows (if otherwise
assigned, the user may use the last column to write down the IP Addresses for future reference):
Description
'FE' Management IP Address
'GE1' (GigE Traffic ) IP Address
'GE2' (GigE Traffic ) IP Address
See Chapter 6. SERIAL‐BASED REMOTE PRODUCT MANAGEMENT for details on
setting up and using the CDM‐800 Serial Interface.
Default Address
192.168.1.10
10.10.1.10
10.10.2.10
5–2
Revision 1
MN-CDM800
User-assigned Address
_____________________
_____________________
_____________________
Advertisement
Table of Contents
