Comtech EF Data CDM-800 Installation And Operation Manual page 117

CDM-800 Gateway Router
Serial-based Remote Product Management
These Instruction Codes are explained in complete detail in the tables that follow. Note that the Target‐to‐Controller Instruction Code
Qualifiers, described earlier, that appear in the "Response to Command" column carry the following meanings:
= Message OK.
? Received OK, but invalid arguments were found.
* Message OK, but not permitted in current mode.
# Message OK, but unit is not in Remote mode.
! Invalid instruction.
Command
Parameter Number of
(Instruction
Type Arguments
& Qualifier)
Default DPW= N/A
Passwords
GE1 Address IG1= 18 bytes numerical Command or Query.
Description of Arguments
Command Only.
Resets the admin username/password to:
Username = "comtech"
Password = "comtech"
Sets the IP Address and network prefix for the 10/100/1000 BaseT GE1 Ethernet
port, in the form aaa.bbb.ccc.ddd/yy, where:
(Permitted ranges – cannot all be zero)
aaa = 0-223
bbb = 0-255
ccc = 0-255
ddd = 0-255
yy = network prefix (range: 8 to 31)
Other restrictions:
If aaa>191, prefix may not be less than 24.
If aaa>127, prefix may not be less than 16.
Example: IG1=010.006.030.001/24
6–9
MN-CDM800
Query
Response to
(Instruction & Response to Query
Command
Qualifier)
DPW= N/A N/A
DPW?
DPW*
DPW#
IG1= IG1? IG1=xxx.xxx.xxx.xxx/yy
IG1? (see Description of Arguments)
IG1*
IG1#
Revision 1