Table of Contents
Advertisement
CDM-800 Gateway Router
Updating Firmware
E. Alternately, use the CDM‐800 Web Server Interface to obtain the firmware information.
•
Use an Ethernet hub, switch, or direct
cable connection to connect the
CDM‐800 'FE' 10/100 Fast Ethernet
port to the PC.
•
On the PC: Use a Web browser (e.g., Internet Explorer) to log in to the CDM‐800
Web Server Interface and access the 'Admin | Firmware' page. Then, make note of
the Slot #1 and Slot #2 firmware loads:
2. Next, create a temporary folder (subdirectory) on the user PC for the firmware archive
download.
•
•
See Chapter 6. SERIAL‐BASED REMOTE PRODUCT MANAGEMENT for
information and instructions on using the CDM‐800 Serial Command Line
Interface.
See Chapter 5. ETHERNET‐BASED REMOTE PRODUCT MANAGEMENT for
information and instructions on using the CDM‐800 Web Server
Interface.
Drive letter "c:" is used in these examples. Any valid, writable drive letter
can be used.
Typical for all tasks: Type the command without quotes, and then press
Enter to execute.
4–3
Revision 1
MN-CDM800
Advertisement
Table of Contents
Need help?
Do you have a question about the CDM-800 and is the answer not in the manual?
Questions and answers