Table of Contents
Advertisement
CDD-880 Multi Receiver Router
Ethernet-based Remote Product Management
CHANGE. THE FIRMWARE INFORMATION (I.E., REVISION LETTERS, VERSION
NUMBERS, ETC.) AS DISPLAYED MAY DIFFER FROM YOUR SETUP.
6.2
Ethernet Management Interface Protocols
The User PC affords access to Ethernet-based remote monitor and control (M&C) of the
CDD-880 through two separately-operated protocols:
•
Simple Network Management Protocol (SNMP). This non-secure interface requires a user-
supplied Network Management System (NMS) and a user-supplied Management
Information Base (MIB) File Browser.
•
The CDD-880 HTTP (Web Server) Interface. This non-secure interface requires a compatible
user-supplied Web browser such as Internet Explorer.
6.2.1 Ethernet Management Interface Access
Access to the CDD-880 Ethernet Management Interfaces requires you to specify the unit
Management IP Address. You may obtain this information via use of a terminal emulator
connected to the CDD-880 rear panel, 9-pin serial 'CONSOLE' port. As shown, a number of
operational parameters (including the unit factory-default IP Addresses) are displayed on the
CDD-880 Serial Interface upon power-up of the unit.
The factory-assigned default IP Addresses are provided in the table that follows (if otherwise
assigned, use the last column to write down the IP Addresses for future reference):
Description
TRAFFIC / MANAGEMENT GE IP Address
'TRAFFIC / GE' (GigE Traffic ) IP Address
Chapter 7. SERIAL-BASED REMOTE PRODUCT MANAGEMENT
Figure 6-1. CDD-880 Serial Interface
Default Address
192.168.1.11
10.10.1.11
6–2
MN-CDD880
Revision 2
User-assigned Address
_____________________
_____________________
Advertisement
Table of Contents
