FIGURE 2-8
Locking screw
Bottom hot-swap
/
latch
8. Tighten the locking screws to ensure the blade server is secured into the shelf
(see
2.6
Connecting External I/O Cables
External I/O cables are connected to the Sun Netra CP3060 blade server, or to the
Sun Netra CP3060 RTM when a rear transition module is used. Information on
connecting each of these cables follows:
For Ethernet connections, category 5e or better network cable is required. One
■
end of the Ethernet cable is connected to a suitable 10/100/1000BASE-T switch
and the other end to one of the Ethernet ports on the Sun Netra CP3060 blade
server. Both Ethernet ports A and B are available on the Sun Netra CP3060 blade
server front panel.
2-16
Netra CP3060 Board User's Guide • April 2009
Sun Netra CP3060 Blade Server Latches and Locking Screws
).
FIGURE 2-6
Top latch
Locking screw